
Industrial Shelving For Warehouse Organization
Industrial shelving for warehouse organization is a boltless steel racking system for picking stock by hand. Upright frames take Q235B cold-rolled steel, shelf levels adjust at 76.2 mm pitch, and each level holds 800 kg to 2,000 kg. Order one bay or a full aisle.
Products Description
Industrial shelving for warehouse organization is the boltless steel racking that turns a bare picking floor into a layout you can walk, label and count. Upright frames are fixed to the slab and shelf beams clip into them at 76.2 mm intervals, so each industrial shelving bay keeps a fixed SKU instead of a pile on the floor.
A single 4 shelf bay of industrial shelving carries 800-2,000 kg per level, depending on beam length and section, so one run stores several tonnes on a few square metres of floor. For the higher range, box beams in 90×67×1.8, 90×67×2.0 or 90×67×2.3 mm take the load under a uniformly distributed load with the standard bracing.
The industrial shelving system goes up without welding or specialist tools:
1. Stand the upright frames plumb on their foot plates, so the column line stays true while you build the run.
2. Hook the beam connectors into the upright holes at 76.2 mm pitch, so a level can be set to the height of the carton or bin rather than the other way round.
3. Drop wire mesh decking or steel partition boards onto the beams. Dividers, bins, upright protectors and column guards fit the same frame. Because every connection is a clip rather than a weld, you can extend a run, move a beam up a notch or break a bay down and re-erect it elsewhere without cutting steel.
Sizes, Levels and Load Capacity
| Upright Frame | 90 x 70 mm cold-rolled steel sections with a 76.2 mm pitch hole pattern, matching common 76.2 mm upright profiles so new bays line up with existing racking |
| Beam | Box beam or step beam with safety clips, sized to the level load and to pallets up to 1200×1000 mm |
| Decking | Wire mesh decking, steel partition boards or timber deck; partition boards let a shelf level sit over a pallet level in the same run |
| Load Per Level | 800-2,000 kg per shelf level; up to 1-6 t per level on the heavier upright and beam combinations, confirmed against the load table before ordering |
| Finish | Epoxy powder coating at 60-80 microns in any RAL colour, over Q235B / S235JR high-tensile cold-rolled steel |
Packing



FAQ
Hot Tags: industrial shelving for warehouse organization, China industrial shelving for warehouse organization manufacturers, suppliers, factory, industrial racking, pallet rack decking, heavy duty metal storage shelves, garage storage shelves, cold room shelving, adjustable fork pallet jack
Send Inquiry











